About saravanan.manthaiyan

saravanan.manthaiyan · 07-11-2017

Hi, I have 2 networks with same subnet ID. I would like to how to configure the SG 500-P28 for make communication between these two network. I don't have background of Networking so i am using the GUI for configuring the router. Host IP 192.168.21....

saravanan.manthaiyan · 07-11-2017

Thanks. I will check

saravanan.manthaiyan · 07-11-2017

Ok, thanks. If i want to go with the above setup, could you guide me on how to configure at SG 500-P28. I was trying to add the Ipv4 interface, but could not add both and it says illegal Ip. VLAN 1 192.168.21.127 255.255.255.128 VLAN 2 192.168.21....

saravanan.manthaiyan · 07-11-2017

Thanks for your prompt response and suggestion. I have seen the below subset table. is it right? if it right, what is the gateway i suppose to use for both network. Subnets Netmask: 255.255.255.128 = 25 11111111.11111111.11111111.1 0000000Wildc...

saravanan.manthaiyan · 07-11-2017

Hi, So, we need to have a different subnet.

Member Since	‎07-11-2017 02:49 AM
Date Last Visited	‎08-18-2017 03:57 AM
Posts	5

User Statistics

User Activity

Configure SG500-P28 as default route of 2 network with same subnet ID

Thanks. I will check

Ok, thanks. If i want to go

Thanks for your prompt

Hi,