Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
In response to your question. This is what the command is doing: When you configure the command traffic-share min across-interfaces you are telling the router to distribute traffic across all paths equally even though the paths have unequal metrics. ...
Having the routing bit set in the LSA just means that it is possible to reach the destination via the advertising router for the LSA. It does not specify whether that specific LSA is the best available path or currently in use. An example of when you...
The first issue is either f0/1 on CUST_LON or the VLAN 1 SVI on the switch need to have a non-0 priority set. If they are both set to zero with OSPF broadcast network type neither will become DR and the adjacency state will stay in 2way. This means ...
Yes, the hub's public IP address is the address that should be specified in that command. The ip nhrp map multicast command tells the spoke router to replicate multicast traffic as unicast to the public IP address of the hub. With the tunnel or no ad...
