Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an issue that is frustrating me to no end.
When I issue the command
RTR(tcl)#exec "show archive config diff file1 file2"
it works like a champ.
However when that same command is called at the end of a longer tcl script it is simply ignored....
So it's the stupid small things that end up the most frustrating.
The answer was to simply add "puts" to the beginning of the line. Apparently TCL was running the command but since I didn't ask it to provide an output......it appeared to me to not...
Here is the script that the exec for diff at the end is not functional.
NOTE the delete exec is functional.
I've read that the diff may fail if there is a lack of memory available, could this be the case?
puts [open "flash:test.tcl" w+] {puts "En...
Nevermind, I ended up getting after it a different way by adding:
action 1.2 puts "!"
after the cli command, this forces the entire "show run" to get dumped, no longer waits for the show run to complete, and then can complete the eem script.
There...
Joe,
I've been reading your posts going back for many years, first post on this forum for me and I just wanted to say thanks for all the effort you've expended here.
I have implemented a very similar set of eem scripts, and 99% of everything is wor...
