Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
All,I have read that one may configure up to 4 priority queues, not using the Modular QOS CLI (e.g. "priority-list" command, etc).For the Modular QOS CLI, PQs are implemented using LLQ ("priority" command), and for this one can only specify a single ...
Geoff, Thanks for the advice.What I am planning to do is to map both classes to the PQ, specifying different arg to priority statement for each. This way they both go into the PQ. I am not sure how IOS limits the rates separately within the same queu...
Dear asapun,Need some clarification on the question - G.711 and G.729 do not include any signaling as such, and the 0.5 kbps does not ring a bell. You should only need to reserve BW for the bearer packets, which would in any case be RTP - the RTP p...
Dear pambosch,The switch is responding to the SETUP with a SETUP ACK, which suggests that for some reason it's expecting more digits from the GW, so it has entered an "overlap sending" state, where additional digits are now expected. No more digits ...
