Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everybody, hope you're all fine. I need your help about an issue I'm encountering with my TOIP installation (Call Manager & Gateway 2911). Since my gateway has been restarted, I'm not able to make or receive external phone calls.After entering the...
Hi everybody,
I'm trying to configure a site-to-site VPN tunnel between 2 ASA 5506-X but my VPN never goes up. I don't see active tunnels from ASDM.
The site A has a public static IP address connected to the interface Ge 1/1 and the site B has a dyna...
So it looks like my gateway has a problem with its motherboard. I set up a new gateway with similar settings and now I think I no longer have DSP issues. When trying to call, I now have the disconnect code 44 :Feb 12 12:19:19.950: //-1/00C3A86A1100/C...
I tried something else. I wiped the configuration and restored it again. But there are some lines I can no longer execute (strikethrough) :dspfarm profile 10 transcode codec g711ulaw codec g711alaw codec g729ar8 codec g729abr8 codec g729r8 codec g72...
Hi all, sorry for this very late reply, I has been busy with other issues last week.Here is the result of "show voice dsp voice"DSP DSP DSPWARE CURR BOOT PAK TX/RXTYPE NUM CH CODEC VERSION STATE STATE RST AI VOICEPORT TS ABORT PACK COUNT==== === == =...
Hi Shalid, I set up the codec g711 on all paths. No success.Feb 1 10:41:38.968: H225.0 INCOMING ENCODE BUFFER::= 20B0060008914A000501401F00430048004100490047004E00450041005500440020004E00690063006F006C0061007300000000000000000000000000000000000000000...
