Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello.I have a problem when trying to access from a workstation on the internal network to an external FTP server using Explicit FTPS. After the server requires the client TLS Authentication the client inits TLS but the connection is closed by timeou...
I have inherited an asa 5510 whit 4GE SSM module installed. The asa runs fine, but i can not use the 4GE SSM ports. Using ASDM or console i can get and configure the gigabitethernet1/x ports but i can not get traffic on it.The ping from the console ...
Hi You know when will be CNA v 6 available?At the moment only CNA 5.8.9.1 version is available and the 2960-plus is not supported. Best regards. SORRY!!!!Version 6 is available from July 8.I will try ASAP. Best regards.
Hello.Sorry by the huge delay on the response.I have checked if client is in Passive or Active Mode. But on the client i can see the error before it enters in acttive or passive mode.The error arises on the credential interchange I think. But creden...
Hi Jocamare.Thanks for your response.The capture I sent was taken after disabling FTP inspection. I am not sure if using passive or active mode, I think was taken using passive mode. I will double check this and recapture traffic asap.regards.
