Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hey,
I have bought Cisco Switch ws-c4948-10ge and i want to install him in my data center.
I have from the ISP 2 diffrent networks
1. 37.19.125.xxx with subnet 255.255.255.224
2. 37.19.126.xxx with subnet 255.255.255.240
How i config the switch to wo...
I have pfsense (FW) custom machine
And I have another problem, When I saved the config of the switch and when I restart the switch, I cant ping to switch but the config is saved. Becuse that I need connect serial cable every time and reconfig the swi...
First - Thank you!!!
You right.. that not look the right way..
If i will put pFsense Fw/router before the switch and connect my own pfsense to the switch, this is better way?
if so, you can explain to me?
p.s. if you want i will ready to pay you.
Yo...
Hey,
I will explain
I have two outside ip rangs with diffrent subnets.
And i want connect the hosts direct to this network (without use internal network)
This is posible?
ISP (2 public networks) -> switch -> hosts (every host assign with public IP)
...
