Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi...Does the AP have the ability to assign IP addresses to WLAN devices which roamed into the area? I didn't want to give my WLAN device a static IP, but it wasn't able to get one dynamically via DHCP as well. Can someone advise?Thanks!
Hi...I have a Cisco Aironet 350 access point. I understand that the access point assigns IP addresses to mobile devices connected to it vis DHCP. How and where do I specify the IP ranges?Thanks!
Hi...If there are so many mobile devices within an area, how do we identify who is at where? Can we use the MAC address? Would that be that of the WLAN card or the mobile device, say the PDA itself?Also, does anyone know how to get the MAC address? ...
I have myself a Cisco 340 series Aironet Access Point and a PC card. I want toachieve a seamless roaming scenario between 2 networks. I would like to know whether networks A and B, each having subnets as111.111.xxx.xxx and 111.112.xxx.xxx respective...
I wired my AP to my server via a cross cable. I've set my AP with a static address of the same subnet with my server...but when I roamed in a WLAN mobile handheld, the handheld says error in obtaining a dynamic IP via DHCP server. I don't know wher...
Ok...from all the replies...am I right to say this:1) The DHCP part only comes into the picture if I want to assign the AP with an IP address dynamically. It is not a DHCP server which assigns my WLAN devices an IP address.2) The AP simply allows a ...
Since the AP does not assign IP addresses, then how can my DHCP server achieve that? I tried but I couldn't assign any IP addresses to my WLAN devices.I saw the BOOTP on the webpage of my access point..it is stated as 0.0.0.0. Am I suppossed to chan...
Thanks for your reply once again...I have tried using my DHCP server which is connected wiredly to my access point. My mobile handheld keeps prompting that it was unable to be assigned an IP address through DHCP. I do not know why this is so...is ...
I'm using a handheld device. It's command prompt is a little different. I tried typing in ipconfig, but it says bad command. I'm currently using visual basic for some programming with the WLAN device. Do you have any suggestions as to how I would...
