Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We split a /24 into two /25 segments:eth 1/1 - 8.23.2.0/25eth 1/2 - 8.23.2.128/25eth 1/3 - 8.8.2.2 - ISP link So the whole /24 lives on the router, but split. When I advertise 8.23.2.0/24 to ISP, it doesn't show up as and advertised route. Is there a...
If I advertise a /20 today and in the future decide to break it up into /24 network statements. Will bgp take the more specific routes?
In the future I would like to break up the /24 advertisements and pin certain /24 blocks to different ISP.
the o...
- Running version 9.6.1
- Have 2 interfaces called internal (10.1.1.x) and server -(192.168.1.x) both security level 100.
Have ACL to allow port 22 traffic from 192.168.1.15 to 10.1.1.47
Packet tracer phase 6 fails with this error:
Phase: 6
Type: NA...
it was port 22 in packet tracer....mis typed. Are you talking about this nat command :nat (internal,server) source dynamic Private-address-space-RFC1918 interface
Are you saying since that is there, I need to have a nat command for the return traffi...
