Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Need help in troubleshooting the following issue.I have a router with the following interfaces:Gi 0/1/0 - Global Routing.Gi 0/1/1.123 - VRF "A"Loopback 0 - VRF "A"Gi 0/1/0 is directly connected to a PC. PC has a default gateway set. I want to ping t...
I am trying to access FTD 2110 using HTTPS, and I am getting "Application Failure" error. It says FDM application cannot be opened. Please try again. I tried "configure manager delete" and then "configure manager local" but that did not help.Can some...
I am looking for a way to downgrade SRU Update on FMC. I have two FMC, one has higher version than other. Due to the requirement, I have to downgrade the update to match with other. I cannot upgrade the lower version. I do not see an option to downgr...
Hello, I have configured Firepower Management Center with the 2019-06-30 snort version file. I am trying to generate an alert when I type "nslookup 8800.org" on my laptop. Right now, it is not generating alert for the same. I tried to look for the "B...
That could be the reason. Need to look more into the route leak on ASR 1002. Thank you for all your help and support. Appreciate it. If I find the solution I will post it here.
I understood that the route for pinging from loopback interface was not there. I added that route to test out but that did not work for me. Here is the ping command I am usingping vrf A 172.16.100.1 source Gi 0/1/1.123ping vrf A 172.16.100.1 source ...
Hi Harold, I tried removing those vrf and route-map commands from the interface and configured the router with two static routes but still couldn't ping the PC (172.16.100.1) using the vrf interface. I tried both the interfaces (Loopback and 0/1/1.12...
I thought I tried this already. It did not work for me. I will give a shot. If it doesn't work then I think I have to change the PC to give a try. The next-hop in the route-map exist. It's on the firewall. I just did not provide the firewall configur...
Hi Harold,The setup is very simple. There are two devices configured, one is Cisco ASR 1002 router, running 16.12.04 version and another device is HP Thin Client PC. PC is running Windows 11. IP Configuration on the PC:IP: 172.16.100.1, Subnet Mask: ...
