Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Does anybody know how an AP1200 will perform running 802.11G on a 10 Meg port? Seems like there would be quite a bottleneck on the wired side. I haven't tried this yet but I may be forced into this scenario for a few months and was curious how well t...
Try to keep from using channel 11 if possible. Microwave ovens will cause problems on APs using channel 11 (if it's close enough to the unit). Also, 2.4 GHz cordless phones can cause AP issues. This sounds like an interference issue to me which is wh...
Do have a copy of the log? Are you running LEAP or PEAP? If you're running PEAP the signal will appear to go away when a user fails authentication. It then associates again, the signal appears to come back, then goes away again when the client fails ...
Check the config and make sure that your AP ports aren't configured with auxiliary vlans. Unless you plan on plugging in an IP phone to the same port as the AP you really only need to have the port configured for a single vlan. Hope that works for yo...
