About Javier Teliz

Javier Teliz · 03-25-2025

Migration Using Cisco Catalyst SD-WAN Manager (formerly Cisco vManage) Note1: Specific requirements:Cisco vManage Release 20.4.1 or later•Cisco Integrated Services Routers (ISR)1100 and ISR1100X Release 20.4.1 or later• Note 2: Migration between Vipt...

Javier Teliz · 08-11-2026

Hi Sam, this is not the expected behavior. The cEdge router should display the MAC address of the directly connected remote device.Could you please share the output of the following commands from the cEdge router?show versionshow platformshow ip arps...

Javier Teliz · 03-25-2025

Migration from IOSXE to vEdge Detach the template attached to the device (if present) In Cisco vManage, select Maintenance> Software UpgradeSelect a router in the table and click UpgradeIn the Software Upgrade pop-up: Select the vManage optionIn th...

Javier Teliz · 07-02-2021

The Match-in-VRF Support for NAT feature supports Network Address Translation (NAT) of packets that communicate between two hosts within the same VPN routing and forwarding (VRF) instance. In intra-VPN NAT, both the local and global address spaces fo...

Javier Teliz · 08-28-2018

Very helpfully your explanation, Thanks Daniel!

Member Since	‎08-16-2017 09:19 AM
Date Last Visited	‎08-11-2026 12:35 PM
Posts	5

User Statistics

User Activity

Migrating from vEdge (Viptela OS) to cEdge (IOS-XE) and vice versa

Re: Cisco SD-WAN: cEdge not Showing Remote Device interface MAC Addres

Re: Migration from IOS XE SDWAN to VIPTELLA

Re: IP nat inside source command with : match-in-vrf

Re: Daniel,