Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I've experience a very strange behaviour with Cat4500E-SUP6L switches.The switches are making only L2 forwarding.When port-security is activated some of the clients are stop receiving DHCP addresses.The interfaces where the clients connected to no...
Hi,I have 2 ASR routers running PIM-SM between them on several sub interfaces.PIM hello interval configured for 200ms.Sometimes PIM neighbors between ASR routers going down.Reboot for each router not resolving the problem.Deleting ip pim sparse-mode...
Hi,I configured 2960S switch as http server.I'm unable to access the switch GUI with non privilege 15 user, with privilege 15 user it's working.Does any one know if this could be done ?
Hi Boris,Multicast traffic is beeing sent to multicast destination ip address.On you ACL it configured as source.Try to configure the ACL like this:permit udp any host 239.5.0.19 eq 5000 permit udp any host 239.5.0.26 eq 5000 ...etc.BR,
