Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am using Cisco ASA 5510 ver 8.0 (2) with ASDM 6.0 (2)I have configured SSL based VPN access for my remote users. But when I enable Cisco Secure Desktop the performance of the access drops drastically and remote users are not able to work. If the...
I am facing probelm while establishing VPN between PIX & FortiGate.The VPN gets established & works for soemtime -- a couple of days & then teh connection suddenly drops.The VPN tunnel comes up only when the VPN tunnel is reset from the FortiGate end...
I have configured Remote access VPN on Cisco ASA 5510 device. I am trying to configur split tunnel for th eusers but that does not work.I am creating an access-list for the split tunnel traffic i.e To Tunnel only traffic for ACLACL test <src IP> <Des...
Hi,We have a Cisco PIX 515E whcih is between the local site & remote site.LAN1 ----Swicth1--PIX FW1---Router1----Router2----FW2---LAN2On FW1 we have nat (inside) 0 acces-list TESTaccess-list TEST permit ip <local subnet> anyIf we remove the FW1 teh ...
We have a site-to-site VPN tunnel setup between two locations one end has Cisco PIX 515E & the remote end is Checkpoint FW1.Now when I initiate a traffic from the end having Cisco PIX the vpn tunnel does not come up ,but when one tries to generate an...
Below the debug frim the FortiGateComes :500->:500,ifindex=8, vf_id=0.... Exchange Mode = 2, I_COOKIE = 0x596D677AF9737E85, Len = 68 checking Mastek 8 -> :500 Mastek: phase1 found Received Payloads= ID HASH Initiator: main mode get 3rd response... M...
Yes nat 0 (inside) acess-list testacl test is allowed anyOne to one natting is done for local machine on the Router 2,hence the nat 0 statement on FW1.The application is an NCR appn for data processing.No port level restriction is applied on amy n/w ...
Will disabling sysopt connection permit ipsec will affect my site-to-site VPN tunnel in any way.I know that sysopt connection command is used to permit only VPN ports between two participating peers.So if I have an ACL applied on the outside interfac...
