Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
I was wondering if anyone knows if there is a limitation or requirement on the type of USB stick I would need to use as a temporary drive1: for a 5515-X. We have a production ASA 5515-X (pre-firepower) that won't allow me to save its configs ...
Has anyone discussed the options with the 5512/5515 models going end of life and whether or not they would consider the newer 2100 models versus the 5516/5525 models? I had a few questions and was wondering if anyone has dealt with the new models com...
I am getting this warning on my ASA 5505 when I try to set up logging from my off site FW to the central FW, which is a 5510. What I am trying to do is send the FW logs through the VPN Tunnel into the central 5510 to our logging server at 192.168.22....
Thanks Ajay,
I did not consider using ASDM as I am a CLI guy... In the end, the ASA did not see any space on the 4gig USB stick after I formatted it to FAT32. I couldn't save anything to the USB.
So I went ahead and performed the fsck disk0: and it ...
Hi Santhosh,
The ASA uses PFS as an optional command - I do not believe there is a default.
You can type "show run all" to see all hidden and default commands on the ASA
Here is a link about IPSEC
http://www.cisco.com/c/en/us/support/docs/security/...
Hi Ve Con,
I have had a similar experience in trying to figure it out. What I noticed was that the serial number of the Standby firewall is a good way to tell which has taken over - otherwise everything looks very much the same. I check to see that t...
Hi Mahesh,
I believe your ping is reaching the firewall, because your log shows it is getting denied. That is a good sign that the ping is getting there.
Do you have an access-list built allowing the two networks to talk to each other?
"access-list M...
Hi Jimmy,Glad you got it working!!If I am reading your statement correctly, it looks like you may have been using private IPs on your outside interface of your firewall? I have not done it this way in a lab. The NAT I used works when your outside int...
