Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I cannot use the Lab’s Web Portal to get information about the resources in your Lab. I can not connect to any devices directly as the Web Portal, does not exist. I can use PuTTY to SSH to device including the Red Hat Servers once I find the actu...
Can anyone direct me to an installation guide for the ACI Starter kit. The hardware is installed, best guess cabling is in place, the power is on. What now? What do I do from cold on the APIC and the Nexus Switches to initialize them.....I see the...
Attempting the transition from learning Labs to sandbox. Tried other Labs without success. Everything spelled out in this Lab (and I have Cisco Spark). Thanks for being so thorough, I can now attempt the other labs.
Thanks for responding ec,I went through the lob documents again. What I can do:Log on to the network devices and one of the Linux servers using SSH. I am a network engineer first and foremost (not a programmer but I am a Python beginner!) Understan...
I am usingCisco APIC Getting Started GuideFirst Published: August 04, 2014Last Modified: November 11, 2014seems to be version 1.0(2j)The APICs are running 1.0(1e)the n9ks are at n9000-11.0(1b)I am try to set up the OOB in a constructive manner....
I have a question.....Network up and running 3 APICs, 2 Spines, 4 leaves, remote access to APICs, and I have managed to set up an oob network and get remote access to the N9k management ports, mgmt0. But in the Out-of-Band EPG Default Screen I get a...
