Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have been trying to get 2611 to work as a Terminal server to be able to reverse telnet to couple of routers. But I can't get it to work on the NM module, however it is working through the AUX port. This is the config of the router:Current configu...
How do I keep a log of the PAT/NAT translations running on a PIX for a future analysis?I have tried to log it with syslog and SNMP MIBs but I couldn't find the right object or line in the syslog.The informations that I am trying to get are the same a...
Hi Nethelper, I'm getting the password prompt from the Terminal server, I have "login" on the lines. I have tried clearing the line and login in again with no luck. I can't see the link you are mentioning. The NM module is in slot 1 on the 2600. ...
Hi Nethelper, How can I know if it is a rolled cabel or not on the Octal cable? I'm getting the password prompt and after that it I have a connection but nothing is displaying on the screen.R.Haukur
Hi HTH, thank you for the response. I have been trying a telnet to the loopback IP address on port 2033, which should be the first unit connected. I have been thinking if it could be wrong cabling on the RJ45 connector. I have these colors: Green,...
