Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a Cisco 9407 as our Core switch. The Spanning Tree Path Cost is set to short as it is on the rest of the switches in our network. We connected a 9200 via an ether channel configuration. The 9200 Spanning Tree Patch Cost was set to long. A...
We have a network that has an interface on our ASA. This network will be moving to a new location and will now be connected to one of our regular layer 3 switches. What needs to be done on the ASA to disable this network and allow the correct route...
I have 2 network printers that are connected to 2 different switches on the same VLAN. The users on local subnet can access these printers just fine. Users on a remote subnet cannot access these printers unless someone on local subnet accesses thes...
I have an NAT from my outside interface to a server on the inside. It also has an ACL that allows port 80. I need to remove this configuration. Which part is removed fist the NAT or ACL? Should do a clear local host when they are both removed?ThanksB...
We have a server that sits in the DMZ. We need to allow users from the Outside interface to access it on the DMZ. The server on the DMZ will need to access a server on the Inside network. Is there a special way to configure that or just standard N...
We installed version 16.03.069 (the default for Spanning Tree Path Cost is set to short) and the switch installation went great. No issues. When you go to version 16.0.6.xx the path cost goes to long by default
The 9400 is a single switch. It is running 16.09.04 The 9200 is running 17.06.XX. I noticed in this version the Path cost defaults to Long. We have other 9200/9500 running 17.03.XX and the path cost is set to short.( it is the default in that vers...
We are running vtp on these switches. There are computers on these switches. They do not have issues. The printers have been powered off and on since we stared having this issue. The 2960's see the vlan.Thanks
