Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have attached a high level design diagram which represents the network topology and multicasting is introduced on the network for camera streams. For multicast using “sparse-dense-mode” and OSPF is used as the routing protocol.Multicast works go...
We have sites which has basic IP connectivity for supporting the data traffic and other applications and using the WAN connections. Currently we have got a new requirement to provision a point-to-point tunnel using serial interface and to connect to ...
Hi, What will be the implication of using a VLAN on MST instance 0. I understand it’s a bad practise to use MST instance 0 for a production VLAN but I cannot rationalise and could not find an answer behind and the reasons behind this. Can someone sha...
Hi,Let me explain about the design before getting into the details. We are a service provider and we have presence across different data centres located across the country. Our core boxes are the mixture of Cisco VXR’s and 6513 switches which have MP...
We have 2 CE routers which peers with the PE router and we aggregate 172.29.190.0/19 on both the CE routers under BGP by using the "aggregate-address" statement. Then BGP is redistribute into OSPF Area 0 to reach the internal networks and we use ospf...
Hi,I believe you are looking for a MP-eBGP peering sample configuration and have a look at the following attached configuration below. I have highlighted the configuration which you need to look at - router bgp bgp log-neighbor-changes ! ! address-f...
Hi Kevin I am using suppress-map to de-aggregate and to inject specific routes in the routing table. If you need further information please let me know I have a scenario handy.Thanks
Hi All,A router reboot has fixed the issue. I don’t have a clue why this happened in the first place or what caused to trigger this to happen. Considering the intensity of the issue, since around 1000 sites are using this links to access their server...
Hi Milan,I saw the "maxas-limit" from the output and searched the routers configuration and i cound not find any lines of code in the running config which has "bgp maxas-limit" and i dont know why it appears there. I am going to double check the runn...
