Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have two pair of Pix 535's, because I ran out of DMZ (10) on one of them. Now that I have the eleven dmz, how should I configure the two 535 to route between dmz 1-10 and 11-20.
I have a pair of Pix 525 and the Failover secondary and Primary time does not match the unit Up time .... should they not match .... the active time only displays the active time of the secondary unit.... the time it failed over... This host: Seconda...
I have three pair of pix firewalls and 5 Cisco Content Engines, when I point the CE at either pair of Pix firewalls, within a few days firewall will failover.... The firewall's that at not supporting the CE does not failover ... has anyone seen any i...
We have a 560 CE, we are doing Radius Athenication, and Websense content filtering. When looking at the websense reports we do not see the user id only the IP address.Does anyone have any experience with CE/Radius and Websense ... does the CE version...
How do you set up multiple Pix firewall to send their syslog data to a single Syslog Server and have a differnet directorys for each Firewall. I currently have one file by Day for serveral firewall's.
No... I have two firewall A and B ... Both have DMZ attached to each of them and I would like to be able to connect Firewall A DMZs to Firewall B DMZs. How should I do this ... (cross over cable between A and B, Shared DMZ segement, Firewall C with a...
I've seen this message when I use the Nat 0 command...(config)# nat (intweb) 0 access-list acl-webWARNING: access-list protocol or port will not be used
