About s.marino

s.marino · 03-09-2009

I'm running HSRP on H1 and H2, tracking the interfaces to the routers and between H1 & H2 Trunk link. I'm routing between R1, R2, H1 and H2's connections. I've been getting mixed reviews on the placement of the Root Bridge. I feel that the placemen...

s.marino · 09-09-2013

Did you run the following command:"clear arp-cache interface" (followed by the interface number)or"clear arp-cache" ( followed by the IP Address)

s.marino · 01-20-2010

jsheriony,For the other router (for dual) you don't see the same output is because the router has CDP disabled.You can also disable CDP on the switch or per port as stated earlier.Regards,Sal

s.marino · 01-20-2010

I agree with Jon and use the following:172.22.96.0 255.224.0.0 (reverse mask for ACL is 0.31.255.255)172.22.128.0 255.192.0.0 (reverse mask for ACL is 0.63.255.255)Regards,Sal

s.marino · 01-20-2010

Please refer to the link below.http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/catos/8.x/configuration/guide/span.html#wp1019981Regards,Sal

s.marino · 01-20-2010

You should check for a hardware failure. Have you tried other fasethernet ports, cabling and is the result the same?Sal

Member Since	‎01-16-2007 01:41 PM
Date Last Visited	‎01-05-2022 12:07 AM
Posts	39
Total Helpful Votes Received	23

User Statistics

User Activity

Preferred Placement of Root Bridge

Re: ASR 1001 Arp table

Re: cdp neighbor

Re: Question on Subnets and Wild Card Masks

Re: Duplicating a span port (copper tap?)

Re: output drops on fastethernet interface