Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Two clients (PC's) -> 2960 -> WGB (1242) -> LWAPP (1131) -> 4505 -> WLCI have two clients (Fa0/1 & Fa0/5) on a 2960 switch and one WGB (1242) connected on Gi0/1 of the same switch. The WGB thats connected to my switch and supports my two clients conn...
I found two ways to resolve the issue. The first fix was a static mac entry mac address-table static xxxx.xxxx.xxxx vlan 20 interface fastEthernet 0/5. We did not go with this option because different wired clients will be moving on and off switch. S...
Rasika,I tried it on another WLAN that does not have mac-filtering at the WLC level. I'm still getting the same issue. Should I try a static mac for the clients port on the 2960 instead?
Thanks for the reply rasikanayanajith,I added the static mac entry into the WGB for the client that was mac flapping on the 2960. I let the command run overnite to see if it helped. It did seem to supress the flapping however every hour it flapped th...
Thanks for the reply sandeepchoudhary21,Even if I use a single client on the switch, it always flapps with the Gi0/1 interface connected to the WGB. I'm not using etherchannels and spanning-tree is turned on. If I unplug the 2960 connected to the WGB...
