Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have initialized the 8 data centre nodes topology from VIRL Sandbox. I can ssh to dist and access switches (NXOS 9Ks) but unable to ssh into other devices (IOS XRv and CSR1000v). The error I get is as below:Couldn't agree a key algorithm (ava...
Hello,
Can someone shed some light on the following questions please?
1. What is the scope of show conn table?
a. all connections through the ASA
b. from lower security level to higher security level
c. from higher security level to low...
Hello,
I have been trying to analyse existing traffic on an ASA and need to figure out active (not stale) xlate info.
If I issue 'show xlate' , it gives me:
Global 192.168.1.1 Local 172.16.1.1
So, how do I find out that if this entry is actually...
Hello,
I have been configuring ASA firewall (asa v9 on Firepower 4K) to integrate with the ACI. The eBGP peerings are up and all works fine. I am trying to achieve multipath load sharing in inbound as well as outbound direction. refer to the diagra...
Hello,
I have one multi-context asa running on the FPR4100. I would like to add one more logical device running asa in a single mode. So, I would have 2 ASAs running on the chassis. Does the FPR4K support it? Just for curiosity, can we have one FTD...
Thanks Kirk. See the answer below:
So what specifically about your SQL server was impacted, storage, networking? - Some RDM disks reported busy: The system failed to flush data to the transaction log.
This servers in question have shared RDM disks ...
Check this doc:https://www.cisco.com/c/en/us/td/docs/switches/datacenter/aci/apic/sw/2-x/L3_config/b_Cisco_APIC_Layer_3_Configuration_Guide/b_Cisco_APIC_Layer_3_Configuration_Guide_chapter_010011.html#id_30270It is mentioned in Guidelines for Setting...
Hi Manuel,
Thanks for your reply. All the nodes are running the same code. Factory-reset of spines resolved the problem but I have no idea why It would be good to know what actually happened behind the scene that made it work but it does not see...
