Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everybody,I´m looking for the best configuration to restrict a user to read-only. The restriction should be configured via CLI not TACACS+.Hardware: 3750 (probably not interesting for this question)Oldest IOS: 12.2(53)SE1The user should be allo...
Hi Community,I recently had some CPU util problems on my 3750-X. The root cause were too many open TCP sessions, which brought the average CPU utilization to 85%. After some research I found a post in the CSC about the IOS 15.0(1). It said, that high...
Hello,it would possibly work with those summarizations:10.82.194.211/3210.82.194.212/3110.82.194.216/3010.82.194.224/3010.82.194.232/3110.82.194.236/32I think there is no easier way to summarize this particular range.Please correct me if I miscalcula...
Hi Bimal,could you also provide the output of following commands:show processes cpu historyshow versionMaybe this is due to a IOS bug which is causing high CPU utilization.
Hi Dev,there is the possiblity to configure one port as a trunk link with both vlans and connect this port to the router. Afterwards you have to configure 2 subinterfaces on the router interface which you connected to. Each subinterface has to be tag...
Do you have storm-control active on this interface? I don't know the time range in which this multicasts were recieved, but you should consider it to prevent high interface util.http://www.cisco.com/en/US/docs/switches/lan/catalyst2950/software/relea...
