Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have my router setup with a gig 0/1 as my primary interface and I'm using cellular as a backup. However, I cannot get outside accessMWA-CTT#sh runBuilding configuration...Current configuration : 2596 bytes!! Last configuration change at 19:24:01 U...
I have been tryign to get a VZW 4G HWIC up and running, but the card shows:cellular0 0 0 is up spoofing line protocol is up spoofingBuilding configuration...Current configuration : 1988 bytes!! Last configuration change at 22:02:09 UTC Sun Mar 17 201...
I have a problem that several have been unabvel to solve. I have gig 0/0 as my primary WAN interface and an Cellular HWIC as my backup WAN interface. Off of gig 0/1 I have a laptop and I cannot get it to route out to the internet unless I disconnee...
Rick - I do appreciate the help. I did change the Access-List to ip nat inside source route-map NAT-Cell interface Cellular0/1/0 overloadip nat inside source route-map NAT-Gi interface GigabitEthernet0/1 overloadip route 0.0.0.0 0.0.0.0 GigabitEthe...
Rick, I made the following changes to go to route-maps, I'm stillmissign something.ip nat inside source route-map NAT-Cell interface Cellular0/1/0 overloadip nat inside source route-map NAT-Gi interface GigabitEthernet0/1 overloadip route 0.0.0....
Here is a new finding. If I open IE and go to you tube and stream a video and then pull gig 0/0. The video will die, but if I open a new IE Window (while gig 0/0 is down) and go to you tube I can play a new video. So that means the IP session is ...
I added the next to the static route on the cell interface because I was seeing no gateway of last resort when I failed over.To answer your question, I can ping from the consol of the router to any public IP and yes the cellular interface is up. I s...
