Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi every one, I´m using a Cisco UCS C220 M3 when I tried to install ESXi 5.1.0 Cisco Custom after complete all the process and restart the server. The ESXi did not start it appeared as if there no operating system.Aditionally, before the ESXi install...
Hi Dagerson,As Manvelas said is not supported. However is it possible to work using ESXi and the Embedded MegaRAID Controller. We have two UCS C220 M3 and one UCS C240 M3 working in that way.The issue is for the first time you try to install ESXi, i...
Hi all,Finally I came across with a sort of solution.I had to Download and Install CIMC Firmware 1.4.7h and BIOS 1.4.7hI had to Download SCU 3.1.4fFirst upgrade or downgrade de CICM and BIOS with 1.4.7hCreate the array using Embeded MegaRAID Controll...
Hi Manuel,I'm using the Embedded MegaRAID Controller and was working great with one disk in RAID 0 where the ESXi 5.1.0 was installed.By a unexpected power-off the UCS lost all the config and I had to reinstall the ESXi.The boot order has the HDD dev...
Hi Kenny,I did the "F6" step and it's the same result.I used Raid 0 because I'm using the Embeded MegaRAID Controller, therefore I only use one disk for the ESXi.Before the UCS failure by a sudden power-off it was working properly using this configur...
