Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 3 small sites connected over T1 using Cisco 2500 series routers. Site A - 10.2.X.X mask 16, B 10.1.X.X 16, and C 10.3.X.X 16. I now have a DSL 678 connection to the internet at Site A. I have the 678 set to be the default gateway for the 1...
It will be a tough go changing my internal network addresses - multiple servers and routers. I tried to change the NAT Pool for the 678 but can not find any commands that allow it. Is it Possible? I am about to head to door 3 - would I enable NAT ...
