Hi all,We have a customer with a UC320 on 2.1.1(7) with this requirement:- Incoming call (from a SIP trunk) first rings a specific extension (say 100).- If not answered in xx seconds, ring all the members of a hunt group (which includes the original ...
Hi -- has anyone any experience of and/or pointers to using a UC320 with phones connected via a C2960G switch?We have this situation. I've enabled CDP and VLAN 100 on the switch and ports, but there are few funny things happening. IOS is 12.2(44)SE f...
Hi all,Not sure where to send these, so apologies in advance. Apologies again if a known issue.We just updated our internal UC320 here in England to the 2.1.0 RC firmware. Nice that the "There are no compatible entries remaining in the directory" voi...
Hi all,We've got a customer here in the UK with a UC320 with a SIP trunk with 10 DDI numbers. Incoming and outgoing calls work fine. What we can't do is make the UC320 generate the right SIP INVITE call to allow the trunk provider to show different o...
Hello,We installed the RC yesterday. Generally no problems. One minor annoyance - we have a button programmed on our phone for Night Service. Whenever that button is pressed (either to set or unset night service), the display shows "SystemNightRingin...
Hi Andrea,We have a UC320 and we use iPhones and MacBook Pro's with it quite happily as well as Windows boxes. Have been able to do so since the first time we installed it. We're now on 2.1.1(7) and the wireless is set to WPA2 Personal AES security w...
Hi,We've got customers using SIP trunks from voip.co.uk with inbound DDI (and now also outbound CLI) quite happily with their uc320s.Simon is the head sales guy on 01869 222500Good luck,Gary
Hi folks.Here's the resolution AFAIK:The issues we were having came down to switchport security. In particular the port that was the trunk to the rest of the network. So, I set the port mode to dynamic and disabled all the security and all the wierdn...
