Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a VPN connection between two PIX' and it works very fine. Now I tried to make some outbound filter for one of the PIX' and my VPN traffic between the PIX' stops.I thought that any traffic in the tunnel allways went through but I may have mi...
Hi,I have configured the PIX to do VPN connections from VPN clients and the clients can see the whole network. How do I configure the VPN to see only 2 hosts at my network and nothing else?RegardsKim Loefqvist
Hi,I have a small problem with my PIX. For some reason I cannot connect a Notes server sitting on my DMZ to a Notes server sitting on my LAN using the public address of my server on the LAN side.I did not have this problem running OS 6.1(1). Do you h...
Hi,You do not need to configure anything on the PIX just make sure that your ISP is routing the new addresses to your PIX - Then you can use the new addresses to what you like.RegardsKim
Hi,Sorry for the delay, but here is my configuration:PIX Version 6.3(3)interface ethernet0 autointerface ethernet1 autonameif ethernet0 outside security0nameif ethernet1 inside security100enable password aaaaaaaaaa encryptedpasswd aaaaaaaaaa encrypte...
