Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi thereI'm looking for a document that states the best practices for WLC configurations (Management/Security/AP's..etc). I can currently only find the following document: http://www.cisco.com/en/US/partner/tech/tk722/tk809/technologies_tech_note0918...
Hi thereI have a Hwic 3G-GSM module in an 1841 router. The sim card in the module is configured on an APN no username and password. I ahve checked all the config from a working router 1841 plus the same module and same vendor som card on the APN and ...
Hi thereI'm strugling with the cifs instance not going to running state, I have tried rebooting the device and reinstalling the software and no luck. Does any one have ideas or had the same problem?sabf-0057-mkuze-wae-1#sh alarmsCritical Alarms:-----...
Hi thereI'm having some issues on WAAS devices with Kernel_crash 's. How can this be resolved?sabf-0051-kuruman-wae-1#sh alarmCritical Alarms:----------------NoneMajor Alarms:------------- Alarm ID Module/Submodule ...
Hi thereI'm trying to upgrade this device WAE-7371-K9 to the newest image that has been released because i'm getting a licensing error, and apperently a image upgrade could solf the problem.This is the problem that I'm encountering:License Name Sta...
Solved the problemthere is a line 0/1/0 config beteeen the con and vty config.. that needed to be tehre as well with the "script dialer gsm" .Hope this helps someone... EX of line config:line 0/0/0 exec-timeout 0 0 password void script dialer gsm log...
Not sure what you mean by full but here goes, the rest has been pasted as cel interface ext:What I left out of Cel 0/1/0dialer-list 1 protocol ip list 1access-list 1 permit anysh cel 0/1/0 allHardware Information====================Modem Firmware Ver...
If there network doesn't have the same IP range as your you can do it with no problem, just make sure that there network doesn't leak into your and vice versa, you can do this by access list on the interface. You can use routing protocals to learn th...
