Hello,Due to high number of APs, I need to deploy a separate MSE to provide location services and aWIPS. In this scanrio, is it possible to share the same floor map which contain local and WSSI APs between the 2 MSEs?the tracking elements pe...
Hi all,I'm trying to find a config example detailing how AP sniffer mode and SE capability can be configured on a Cisco 3600 that is equpped with a WSSI. I came across the WSSI deployment guide which does not go into the detailed that I would like t...
Hi all,the data sheets provide the number of max supported APs on different controller platforms.However in practise typically services can get affected before reaching this threshold.for obvious reasons no vendor will come out and state the practic...
Hi all,http://www.cisco.com/en/US/docs/wireless/controller/7.2/configuration/guide/cg_rrm.html#wp1412564states that the max number of APs per RF group is 1000.However WLC 7.3 or 7.4 does not specify this limit at all.Just wondering how do go by det...
Hi Muhammad,OE stands for Office Eextended APshere is the link for the config.http://www.cisco.com/en/US/products/ps11579/products_tech_note09186a0080b7f10e.shtmlEnjoy!.cheers
Hi Madhuri,Thanks very much for your reply.I do have one final question. Does the standby WLC check the network connectivity (ICMP to GW ) in parallel with exchanging keepalives with Active WLC? To me the algorithm indicates that the icmp kicks in...
Hi Maduri,Say we have a VSS based setup with WISM2s and assume we also purchase HA-SKU for the WISM2.Let me expalin the scenario.If we loose power to one VSS chassis will cause the APs to failover to the standby WLCs. Now when power resumes, t...