Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello community,I'm scratching my head over this one. After battling to get a working 3G configuration using the new 3.75G HSPA+ card, which is now working with no problem for Internet access, I'm struggling to bring up a DMVPN connection to our hub ...
The 3925 has 4 WIC slots and 2 SM slots - you can get a converter that turns SM into NM (SM-NM-ADPTR) and maybe even one that turns an SM into HWIC too I think (maybe SM-SLOT-DIVIDER, never used it myself) so I don't see the problem?
Hi,Ok - no problem. Please add 'network 216.224.132.160 mask 255.255.255.224' under BGP config. It will only advertise it when the static route is in the routing table which is when the SLA is up.Sent from Cisco Technical Support iPhone App
Hi,Can you use the 'show ip bgp' to see if there is any change to the prefixes you have in BGP table when the object goes from Up->Down and visa versa?Sent from Cisco Technical Support iPhone App
Hi,Oh OK - that's not the HSPA+ modem, so I believe Sandeep's link to the configuration guide should work for you.Regards,JamieSent from Cisco Technical Support iPhone App
Hi,My experience with the 819 documentation was that it was copied from another 3G spec and not actually confirmed to work. e.g PPP encapsulation wasn't actually supported on my modem in the 819 despite it being in the documentation, so SLIP had to b...
