About mitch_santos_21

mitch_santos_21 · 10-23-2012

Hi Everyone,I have a problem with EX90 and EX60 Telepresence, here are the scenarios:1. When telepresence is making a video/audio calls to another telepresence locally, it is ok and succesful. (Take note: MTP required is not checked) 2. When telepres...

mitch_santos_21 · 10-28-2012

Hi,I was able to solve this problem with the help of Cisco TAC. The resolution we made is creating a SIP trunk for all IDD/mobile calls in CUCM and creating a SIP dial peer in voice gateway. The DTMF signalling method on the trunk is rfc2833. The dtm...

mitch_santos_21 · 10-23-2012

Hi,I already tried to add that config, however voice prompt of "unable to authorized...."here is the dial peer config.dial-peer voice 21 voip preference 1 destination-pattern .... session target ipv4:10.0.220.1 dtmf-relay h245-alphanumeric codec g711...

mitch_santos_21 · 10-23-2012

In RFC 2833 and OOB method for DTMF signaling, do we need to made some configuration in both voice gateway and CUCM?Thanks and regards,Mich

mitch_santos_21 · 10-23-2012

Hi Alok,The gateway type is H323.Regards,Mich

mitch_santos_21 · 10-23-2012

Hi,Please be advised that the protocol used for EX90 is SIP. How do we know if the MTP use supports more than 3 RTP channels? What do you mean by "focus on getting it to support RFC2833 DTMF"? Can you please elaborate it? Does it mean we need an RFC2...

Member Since	‎06-10-2012 10:22 PM
Date Last Visited	‎08-18-2017 04:00 AM
Posts	8

User Statistics

User Activity

Telepresence cannot make a video call locally when MTP required is enabled

Telepresence cannot make a video call locally when MTP required

Telepresence cannot make a video call locally when MTP required

Telepresence cannot make a video call locally when MTP required

Telepresence cannot make a video call locally when MTP required

Telepresence cannot make a video call locally when MTP required