Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiWe installed 20 access point (1310 LAP) in 4 km tunnel ( each 200 meter one ap) for vowlan projects with 7925g phones .on each radio we have 2 antenna (AIR-ANT2506) and diversity is enabled .But we have problems like one way talks or weak signal ....
Hi ,We have 3 seperate network with 3 diffrent ssid with one call manager.on all phones we set 3 profile , but when phones run through networks they stucked in last network and shows leaving service area .they could not switch fast betwheen networks ...
Hi ,We are going to setup VoWlan in two 5 Km Tunel with Cisco AP and phones . ( We have Fiber and ethernet as backbone for each AP)We already done a sample project in 2 km tunnel with Cisco 1552 Ap and 7925G phones + 5508 Controller.But For this new...
Hi ,We have just finished installation of 12 AP 1552 as access points , clients are 7925G phone , after installation and configuration all clients can register and access to AP's in wireless environment but in IP we can't access to phones from our se...
What about multipath in tunnel? we have concrete walls and some curve in tunnel. tunnel width is almost 12 meter . could it be couse of weak signal? should i go for 802.11 g or to increase power go to 802.11b and lower bandwdth like 11 or 5.5?
Becouse of weak signal in some area i set it in manual mode to 1 , another interesting point is no one of access point not using channel 6 , just using channel 1 and 11 .I surprised becouse as you said radio is power full enough and i tought 20 ap is...
Ok , i will go with same ssid for wlan , but could we use 3 diffrent network setting ? for example network 1 192.168.1.0Network 2 192.168.2.0 and network 3 192.168.3.0 for 3 area . all 3 network have routed to call manager and have access To that .A...
Dear amjad ,what you mean about exact same configuration in wlan configuration page ? same ssid and same security? so what is usage of profiles? Thank you
Hi Thomas ,As i said we have budget problem becouse of that we choose 1310, is it too far ( 300 meter) for those ap?We already deployed with 1552 each 350 meter and it is working well .
