Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Has anyone had success with getting the Sponsor Portal to provide the sponsor information for guest accounts? This would be a very helpful piece of information.If this information is not displayed on the homepage, can it be made available in the det...
After numerous conversations with Cisco Account team and Cisco AS that configuring multiple ASAs to go through a single IPEP was not an issue and would not require reconfiguration rebuilding of the addressing on the units. It appears from the exampl...
I have been looking to see if under the new code versions we can do multiple definitions of the NAT like to old multiple global statements. Old methodnat (inside) 1 10.1.0.0 255.255.255.0global (outside) 1 192.168.1.3global (dmz) 1 172.16.4.4 will th...
Anyone else notice that the latest in the 7.2 ASA code train changed the functionality of one of the most basic of commands. This change was also not documented in the release notes. We went to this release due to the last round of security issues....
I am currently running a PIX 535 running 7.0(4) code and was wondering if there was a way to get a list of the top number of flows from local-hosts? I know the local-hosts command will display in the information but am hoping that there is a way to ...
I think that the first second unit may be the cause of the problem it has two maps attemtping to the same peer, with overlapping maps. I would remove this section of the config. crypto map outside_map 1 match address outside_1_cryptomapcrypto map out...
What traffic are you allowing through the VPN tunnel in your access-list? Usually when I see this problem the access list is set up too restrictive and is not allowing the traffic to pass, Have you done any syslogging or debug logging to see where t...
We are currently experiencing the same issue with norton ghost and our fswm, we have upgraded to 2.3(2) and the problems continues. Have you received any insight or fix for Cisco for this issue? Thank you. Rich
