Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, please refer to the following document from Cisco which explains step by step process on recovering/resetting your password on the switch. https://supportforums.cisco.com/discussion/12301261/how-do-i-erase-data-cisco-3560-switch-wont-boot
At that time, we were not using vMotion at all. All our virtual machines were using local storage so vMotion was not possible. Now we use a EMC VNX SAN.Shahid
You are correct. If all the virtual machines are on a single Vlan, the network port could be set up as access port on a single Vlan and tagging is not required. We used this scenario many years ago when we ran 2 lines for each Vlan but now we are usi...
I would agree with Gregory. So the answer to your question would be, no it not possible to have an interface show DOWN/UP. Layer 1 must be up for layer 2 to be up.Sent from Cisco Technical Support Android App
