Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi ,
We have a customer requirement that they want to give priority for Voice traffic over the other internet traffic.
they have 6 Mbps internet link. ASA has 2 interfaces configured, inside and outside. ASA 5510 , s/w 9.1.2.
they hosted their VoIP ...
Hi,
Anybody can provide the corresponding NAT stmt for version ASA 9.2 ?
static (inside,outside) tcp interface https 10.1.1.2 https dns netmask 255.255.255.255 0 0
Thank you
Hi,
I am converting ASA ver 6.3 to 9.2(4) for ASA 5505 hw.
there are more than 30 s-s vpn tunnels which needs to be converted, the existing config of a tunnel is
6.3
name 10.16.34.11 TEST-PEER
isakmp key kE87ber1 address TEST-PEER netmask 255.255.255...
Hi,when the external logging is configured for event logs, does the NIPS/sensor sends the logs directly to the syslog server OR the logs can go only via FMC to the syslog ?Thanks
Hi Karsten,
Thanks for the reply..
Could you please provide the configurations for your above recommendations.
The customer doesn't care about the drop of internet traffic.
Does the other end device (CE router) also needs to be configured with the Q...
Hi, thanks for your reply.
I changed to " asa(config)# tunnel-group 10.16.34.11 type ipsec-l2l" , its ip address,
but not sure this will work and dont know about other side config. need to test it.
Could you Please confirm the below conversion is correct. 3 parts1>access-list inside_outbound_nat0_acl permit ip 10.2.0.0 255.255.255.0 10.11.1.0 255.255.255.0access-list inside_outbound_nat0_acl permit ip 10.2.0.0 255.255.255.0 10.6.6.0 255.255.255...
Thanks much for letting us know this tool, Its very helpful for me...
But if I remove the "dns" from the config then only its taking,
also the tool is not converting if "dns" is present . is there any way to configure "dns"
nat (yzpat,rzpat) source ...
