Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am running MPLS VPN with RIP and OSPF at CE ends.* OSPF for R3 - R1(ospf process 3) and R4 - R5 (ospf process 4) * RIP for R4 - R6I am using two vrfs CA( for R3-R1 and R4-R5) and CB (for R4-R6).for R1 at R3ip vrf CA rd 1:10 route-target export ...
Hi,I am trying to implement PPP chap Authentication on two routers connected via serial interfaces. I just want to know which router will call which router and which router will challenge which router.But according to following link of ciscohttp:/...
Hi All,I have two routers R1 and R2 configured with multilink. Everything works fine when both the links are working fine but when one of the link becomes flapping link then ping response also suffers with many RTOs. Then i have to shut down the flap...
Hi Paul,Yes, I tried.. changing domain id on R4 as 0.0.0.3 but it did not helped. Also domain id only ment to convert OE2 routes to O IA. I don't think it can impact because when ospf router are redistributed in BGP then BGP takes OSPF metric as MED...
Hi Sir,It means the router with "PPP authentication chap callin" command will raise the challenge..But what about the cisco document ??? Is it wrong.??
Hi Sir,Following is the debug output:->>>>>R1<<<<<<R1(config-if)#*Oct 5 13:12:30.227: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial1/0, changed state to upR1(config-if)#*Oct 5 13:13:16.387: Se1/0 PPP: Authorization required*Oct 5 13:13:16...
I think you should ask your ISP to provide single 4 MB ethernet line instead of two 2 MBs. This will be beneficial for you. Otherwise, In my views, only load balancing is possible.
