If NAT is configured and operational, with Fa0/0 being inside, and Ser0/0.1 being outside, is it possible to use an ACL to permit specific inbound traffic on ser0/0.1? Presently, an ACL is set up to allow ICMP echo & echo-replies inbound on Ser0/0.1....

We are running NAT overloaded on a 2610, IOS 12.0(7). The external interface is m.n.o.21. 1 global IP (m.n.o.25) is static natted to our mail server on port 25. Our default route =Ser 0/0, network m.n.o.0, next hop = m.n.o.22. This has worked well to...

I have been studying Cisco docs for a couple of weeks now, and haven't figured out how to log and view traffic. We run a 2620 as a internet gateway, and I have managed to implement NAT, apply access control lists, enable SNMP traps, setup a syslog da...