Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I have a question on routes on a cisco asa. I setup a firewall for internet for IT users. The firewall has a management interface that we use to manage it from specific jump servers.
The issue is that the IT Users need to access the mgmt(jump...
Hello, we have a firewall with a few interfaces. there is a basic nat setup from inside to outside for internet. We are going to be routing a public block through this firewall for internet. The reason is there is a content filter appliance inline fo...
Hello,I am setting up a proxy for webfiltering. I want to run wccp with it instead of putting it inline. In the infrastructure I currently have a 3750 switch. Im looking for a Router to run wccp with. Or should I use the 3750 switch? What router woul...
Hello, Trying to setup bluecoat proxysg and cisco asa using wccp. I have had some feed back saying this is not a good idea. Has anyone successfully setup a cisco asa and used wccp to communicate with a proxy for web filtering? My other solution would...
Hello,I was wondering if there was a way to have two syslog hosts configured on a cisco asa and have diff. severity of logs go to one host.. and another severity of logs to the other host.any info would be helpful.Thanks.
Ah thank you for the response.
Interesting about the 9.5 update. Thanks
I think I will look into the outside interface and investigate the 9.5 code upgrade.
Im running Version 8.6(1)2 and its a ASA5525. What version is recommended for this model?
T...
what would be a no nat statement on an ASA for a specific subnet to not be nated to the outside interface? Cisco Adaptive Security Appliance Software Version 8.4(2)8Device Manager Version 6.4(5)
Cool. got it.. I was looking at it from an ASA perspective to make sure i can nat public to another public. But basically we have network that has raw internet...and instead of re-iping everything on it. We decided to just give it a default route to ...
Thanks for the response. so we would have two ASAs in HA. Then on the 2 physical switch that the firewalls connect to. I would hang the bluecoats off of them. Then run wccp with each bluecoat. Can I run wccp from one switch to one bluecoat.. then wcc...
Hi Thanks for the reply,Yeah we were trying to get it working with cisco asa but it was sluggesh and had intermittent issues. The vendor bluecoat stated that they suggest using a router or layer 4 switch and tend to not suggest using an ASA.if i use ...
