Hi,I want to know how are the EFPs load balanced in the egress direction inside the etherchannel. The port-channel contains the service instances.For Example: If there are 4 member links inside the port-channel and 3 service-instances. For the egress...
Hi All,Please help me regarding this. I need an urgent solution to this.Currently we have cisco 7609 router connected to the extreme switch via 4X1 gig interfaces bundled into a port channel. The port-channel is running 4 service instances. But w...
Hi All,I am confused about the aforementioned concepts, it would be helpful if some one can explain or point me to relevant documentation. Also i would like to know when do we use NSF comapared to NSR specially when using the routing protocols O...
Hi,I understand the port numbering(line card) inside ASR 9000 follows this format "rack/slot/instance/port".If ASR 9000 is using Modular Line Cards, for example two "MPA-4X10GE" inside slot 2. Then how is the port numbered?I am guessing like this : 0...
Hi,Hope this CISCO documentation helps. Since the licence is permanent hope you got a PAK to generate the licence key.http://www.cisco.com/en/US/docs/routers/asr9000/software/asr9k_r4.2/system_management/configuration/guide/b_sysman_cg42asr9k_chapter...
Hi A,Thanks for your prompt reply, MPP feature was a good read. But my customer is always conservative about changing config in a production router though I will propose it to them.In the mean time, will a ipv6 source address be able to bypass the vt...
Hi Ivan,Thank you so much. One more question, if I need to have some redundancy in the boot sequence what can i use instead?Is disk0: which is an external flash be an option? Best RegardsSaikat Chakraborty
Hi,As requested,boot-start-markerboot system flash sup-bootdisk:s72033-advipservicesk9_wan-vz.122-33.SXI8a.binboot system flash slavesup-bootdisk:s72033-advipservicesk9_wan-vz.122-33.SXI8a.binboot-end-markerAttached are the logs. There are one more 6...
