Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I can't for the life of me find an answer but I thought there was some extra "notes" for upgrading two 5508 controllers in a mobility group. I have about 150 AP's (1140 series) and would really like to minimize the downtime as much as possible. My ...
Hello,We currently use 1142's from a WLC 5508 without any real problems except for one heavily populated area. The problem is that nearly half the clients are WYSE thin clients streaming their VMWare View session. This ties up the AP and eventually...
Hello,I have two 5508 WLC's setup to run about 200 AP's as the moment. This is a hospital with patient care now running over wireless. I am looking for the best scenario to minimize down time. Currently both controllers are in the same mobility gr...
Problem: The network speed of our wireless networks have slowed down to about 3 Mbps currently while standing under an access point (Excellent signal strength)Setup: Cisco 4404 controller with mix of LWAP 1121 and 1141. Multiple SSID (Voice, Patie...
I have read some instructions for changing the timeout’s and polling. Does anyone recommend this or are the defaults acceptable? I want minimal downtime but I also need stability. Anyone have horror stories they want to share or some best practice a...
Both WLC's are in the same subnet. I had one AP out of six in a patient area switch over to the secondary and there was a strange delay when clients moved in and out of that AP area. I figured it was relating to a different management IP or somethi...
So it turns out that we were simply flooding the AP's with too many requests. I ended up removing support for 1 and 2 Mbps transfer speeds and adding two additional AP's in the area to help. We are limping along for the moment until I can replace t...
The 80 are spread out over several different facilities. We just paid to have a survey done and expanded the units to create a zero outage coverage of the main site. I don't see too much channel cross except in multi floor areas. I am hoping to in...
