Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a situation with some lab instruments that all have the same IP address 192.168.100.1. This is built into firmware and changing it is not possible. So for me to have these instruments connect to specific hosts for managment purposes I need ...
I am having a similar problem. I have a site to site tunnel with 3 subnets involved, 2 are clients access a server on the other side and one is a number of servers communicating to a server ( same one actually ) on the other end. A clear ipsec s...
Actually, yes, I guess you can say that since I am nat the address of the instrument to different IP's to communicate with the host which could be viewed as in front of the firewall. The host IP is its real IP and the instrument IP is Nat'ed to allo...
Through a layer two switch which the firewall will be connected to.each instrument has same ip and they would be mapped to a IP that would be different for each connection on the asa then routed to the host via a layer 3 switch, obviously an interfac...
The instruments all have a different ethernet network interface if that is what you mean...but if you mean the asa will have a separate interface for each instrument, no that would not be the case.
