Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I really need your help, I'm a beginner.I can't ping one (public) address with my Cisco 892 router. I can acces to the internet, DNS are good, my ACL is "permit any" and I still can't ping this address from my network.But I can ping it with a c...
Hi,Before I have to say that I'm french, so, I'm sorry if I make some language mistakes.I have juste a question about subnetting, I wonder if the Cisco RV082 is able to work with 4 subnets (/26). In each of these subnets, there's approximatively 20-3...
Ok thanks,I enabled "debug ip nat" and I get this (beginning) .My public address is 81.56.134.135Header 1Sep 17 07:49:22.055: NAT: expiring 81.56.134.135 (192.168.0.225) tcp 57937 (57937)Sep 17 07:49:22.083: NAT*: s=192.168.0.28->81.56.134.135, d=92....
Thanks,When I ping this address with "debug ip icmp" enabled, I get this :ReplySep 16 12:06:47.904: ICMP: dst (81.56.134.135) port unreachable sent to 77.194.230.26...Success rate is 0 percent (0/5)routeur-sdtech#Sep 16 12:07:38.052: ICMP: dst (81.56...
Oh ok, I always thought there was a DHCP serveur on these access points.So I think, the only (best) solution is to buy a Linksys WRT54GL wireless router and connect it on my RV082..
Thank you,So I can use my four subnets but I can't use the DHCP.This is not an issue, all the machines will be on static addresses. I just need DHCP for the wireless connections, but the cisco access point wifi can do that, right ?
