Stephen Carter
Level 1
Level 1
Member since ‎04-13-2010

User Statistics

  • 34 Posts
  • 1 Solutions
  • 0 Helpful votes Given
  • 5 Helpful votes Received
Recent Badges
10 Replies
1 Helpful Vote
5 Replies
1 Accepted Solution

User Activity

OK, so I've got a set of ASA's and we are migrating them to Firepowers, and all seems ok. In the past we have noticed that for some reason on the ASA's, no matter what you specify as the parameters for phase 1, the rekey timer always connects at 3600...
OK, so I have 2 firepower 1200's running the same s/w, the same configuration, everything is the same (apart from the specific vpn config). I have a customer with a single end point and from each firepower I have a VPN IKEv2 point to point link. On t...
We have Cisco 927 routers, C927-4PLTEGB versions, and from time to time we have to install these in locations where the mobile signal strength isn't great - so we are looking at using extension cables. However the 'standard' one is only about 10m lon...
Hi there, We've just upgraded to Firepowers (1120's)  from ASA's and are trying, well have got working, route based VPN's. The 'issue' I'm having is that when I use the GUI to create the VTI interface I get the enclosed error message. "IPv6 Source A...
OK, i have a problem and an wondering what the best solution is. Issue - We have 4 servers, A,B,C and D. They all between them run / support a website On the GSS, we want to have them in the following answering pattern -  Request to
Community Statistics
Member Since ‎04-13-2010 04:14 AM
Date Last Visited ‎04-26-2024 02:32 AM
Posts 34
Total Helpful Votes Received 5
Helpful Votes From