Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is it possible in Cpam to assign multiple doors to one reader/gateway. Here is the situation. The customer would like to set up one reader to activate outputs depending on which card is swiped, for instance if the swipe card 1 then output 1 will...
That warning message you are getting when trying to set the NTP settings through the Web interface can be a little Confusing. When it says that it is not allowed while server is running what it is actually telling you that it will not allow you to ch...
Did you apply the credential template to the reader?Go to Templates-->Device Templates-->Then select the reader that you are using.About half way down the page you will see a list of available templates on the left and the templates that the reader i...
I have used the IP Force product before but I have not set up a stream into VSOM as of yet. I have set it up for other products though so it should be pretty much the same procedure. In order to stream the video stream from the IP Force to a third pa...
I have done something like this before but it was for opening multiple lockers using only one reader.I don't think I would reccomend doing this on an elevator as this uses global IOs. so if your gateway loses connection to the server for any reason y...
