Hi Jorge,
I run UCSPE in VMware Workstation Pro. In my install, VMnet8 is setup for NAT. All 3 of the UCSPE interfaces are in that port group.
I can then access the GUI via the assigned DHCP IP at booting.
Regards,
Dave
Hi,
If the EMC storage will "go away" after migration, why not just add the NetApp WWPNs into your existing zones?
Since you mention "boot LUN's", I think you will need to reinstall OS/Hypervisor on new NetApp Boot LUN.
Do you separate Boot LUN fr...
I was pretty competent in an older version of UCSPE to add and delete devices. But I was _really_ struggling with the device inventory in 4.1.2c until I found this YouTube video: https://www.youtube.com/watch?v=KQ8sHagBrzY
Hope this saves you some t...