Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HSRP maintains the active router via multicast hello messages. If a standby router fails to hear hellos from the active router within the alloted time, it will become active. From the network description, no link exists between Router 1 and 2, so the...
If a host IP falls within your VLAN 2 IP range, then it's port should be given the following commands:switchport mode accessswitchport access vlan 2Same applies to host IPs within your VLAN 3 range.I'm not sure what size subnets you are running but a...
Well, you can match specific traffic with ACL's, define the bandwidth limitations with by defining the QoS policer with burst limits and exceed actions, define the traffic classes and group your matched traffic in these, then define a policy-map and ...
When you say "going on/off net", are you referring to users exiting your LAN to the WAN and vice versa via a router or are you referring to strictly LAN/L2 traffic moving inbetween different portions of your LAN?
