Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
umatched commands set to denycommand "configure" argument "permit terminal"user has full access to all. i just want user to adjust vty lines. I also have the following commandsshow with argument"permit run and start"thats all i have set up in command...
i do not have that in my config. I do not know where i would put it. here is my configaaa new-modelaaa authentication login default group tacacs+ lineaaa authentication login no_tacacs enableaaa authentication enable default group tacacs+ enableaaa a...
I actually set up the commands using that document. it is supposed to deny anything else once you are in the config mode. because i have no other commands or arguments defined. but i have full control
