Hi All, I have a number of PEs peering with a RR, the aim is for these RR-clients to exchage their customers routes via the RR.Now looking at the configuration below, i cannot see the need as to why "address-family ipv4" should be present in...
HI All, I will appreciate if anyone could help with a thourough educative explanation as to why the CSC-CE should advertise it local internal routes?.It became confusing because it link to the CSC-PE (IGP-LDP) already made the CSC-CE (local...
Hi All, Your urgent help is hereby sought for the scenario as follows:Four PE routers (R2,4,5,and XR1) each with its connected CE. Running static route everywhere except in the core.The VPN policy actually took place on the R2, which has conn...
Hi All, I have a core network with four routers (R2,R7,R8 and R9). These routers must all run ISIS ipv4 and ipv6 on all their connected interfaces including the loopkbacks. This i achived without any hassle, (see the config and the routing t...
Hi All, Can someone please help me out with what the below error message means and how to get rid of it. %CLNS-3-BADPACKET: ISIS: LAN L1 hello, bad circuit type 0 from ca01.1320.0038 (GigabitEthernet3/0)Without any debugging on, some of my r...
Hi Blau, Many thanks for your reply to my query. Unfortunately my question wasn't answered yet.Dividing the configs into three, i know the first part establishes the TCP session, the third part enables MP-BGP between the PEs.Now the second...
Hi Giuseppe, I am most grateful for taken your precious time to respond to my query.Taking the opportunity of having you around, please allow me to ask for a further clarification. CE SITE-A | ...
Hi Saurabh, A very big thanks for your reponse because i know it takes time going through all the configs before anyone could reply to my query. Nonetheless, your proposed solution could not resolve the issue yet.Please see below for...
Hi Ivan, Your answer was super!!!!!! (i was laughing when i saw your reply), unknown to me i was struggling with configs not knowing it was only the AD issue. Now i have partly resolved the problem by increasing the OSPF Distance to 200 but...
Ivan, Thanks for your willingness to assist. Unfortunately, i cannot understanding why you wants me to add "ch" to the "ip router isis" under the interfaces because the router process does not contain any NAME/TAG. Below is my original configs....